Chemfix
High Perfomance Porcelain Fix
Description
CHEMFIX 701 is a factory blended, cementitious, polymer-modified tile adhesive designed for high bond strength and reduced
vertical slip. It is supplied as a ready-to-use dry powder requiring only clean water on site.
Recommended Uses
• Interior and exterior fixing of ceramic, porcelain, terrazzo, marble and natural stone tiles.
• Suitable for walls and floors, bathrooms, kitchens, wet areas, balconies and general facade applications.
• Suitable substrates include concrete, cement-sand screeds, cement renders, blockwork and existing sound cementitious surfaces.
• For highly deformable substrates, heavy vibration, or special tiles, consult Chemfix Technical Department for the correct system and primer.
• Improved cementitious adhesive with reduced slip.
• High polymer modification for strong adhesion and durability.
• Excellent workability, easy trowelling and good sag resistance on wall applications.
• Water resistant after curing and suitable for wet-service areas.
• Ready for use: add clean water only.
• Use clean cool water only. Add 4.8-5.2 liters of water into a clean pail for each 20 kg bag.
• Add powder gradually while mixing with a slow-speed drill and paddle until a smooth, lump-free paste is obtained.
• Allow the mix to stand for 5 minutes, then remix briefly before use.
• Substrate must be sound, clean, dimensionally stable and free from dust, laitance, oil, grease, curing compound, paint or loose material.
• Dampen highly absorbent cementitious substrates if required, but avoid standing water.
• Apply adhesive with a suitable notched trowel. Comb adhesive in one direction and fix tiles while the adhesive is fresh.
• For large-format tiles, exterior areas, wet areas or heavy-duty applications, apply adhesive to both substrate and tile back to achieve full coverage.
• Press tiles firmly with a slight twisting motion. Check periodically that full contact is achieved.
• Remove excess adhesive from joints and tile face before hardening. Leave minimum 24 hours before grouting.
Coverage depends on substrate flatness, tile back profile, trowel angle and required contact area.
• Do not apply below +5 deg C or above +35 deg C, or in direct hot sun without proper protection.
• Do not apply over metal, painted surfaces, weak gypsum plaster, wood, plastic, bitumen or unstable substrates without an approved primer/system.
• Movement joints must be provided according to project requirements and good tiling practice.
• For swimming pools, submerged areas, special stone, large-format tiles or deformable substrates, consult Chemfix Technical Department.
• Store bags off the ground, under shade, in dry conditions and protected from moisture.
• Contains cement and may cause skin/eye irritation. Wear gloves, mask and eye protection.
• In case of eye contact, rinse immediately with clean water and seek medical advice if irritation persists.
This information is given as per our experience. Users should always refer to the technical data sheet prior to the application. Chemfix denies all responsibility in case the product is used wrongly. All consumption mentioned is theoretical and varies for different substrate and conditions.